Modular 70/80 BRE Serie Installation-Emploi-Entretien page 17

- Knob of gas tap or valve not pressedsufficiently.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
-
Insufficient gas supply pressure.
-
Blocked tubing or nozzle.
-
Defective gas tap or valve.
-
Defective burner (gas outlet holes clogged).
-
Defective energy regulator.
HEATING CANNOT BE ADJUSTED.
Possible causes:
-
Defective energy regulator.
DIFFICULT OR NOISY OPERATION OF THE PAN
MOVING DEVICE
-
Worn screw nuts require replacement.
-
Poor engagement of moving parts (screw, nuts,
bolt, pins, levers, etc...).
ELECTRIC BRATT PAN
THE APPLIANCE DOES NOT HEAT.
Possible causes:
-
Heating elements defective.
-
Temperature thermostat defective.
-
Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
-
Temperature thermostat defective.
DIFFICULT OR NOISY OPERATION OF THE PAN
MOVING DEVICE
-
Worn screw nuts require replacement.
-
Poor engagement of moving parts (screw, nuts,
bolt, pins, levers, etc...).
All manuals and user guides at all-guides.com
17
MULTI-PURPOSE APPLIANCE
THE APPLIANCE DOES NOT HEAT.
Possible causes:
-
Temperature thermostat defective.
-
Heating elements defective.
-
Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
-
Temperature thermostat defective.
20. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE
CARRYING OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS BRATT PAN
REPLACING THE GAS VALVE, THE PILOT BURNER,
THE THERMOCOUPLE, THE ELECTRIC IGNITION,
AND THE IGNITER.
- Remove the bottom front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER
- Remove the control panel and internal guards.