Modular 70/80 BRE Serie Installation-Emploi-Entretien page 13

Do not obstruct any air vents or drains present on
the appliance.
Do not tamper with appliance components.
Keep this manual in a safe place, known to all
users, so that it can be consulted throughout the
working life of the appliance.
Installation and appliance maintenance must be
carried out by qualified technicians authorized by
the manufacturer, in compliance with current
safety standards and the instructions in this
manual.
Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified technicians
manufacturer, in compliance with current safety
standards and the instructions in this manual.
11. USING THE GAS BRATT PAN
The appliance is designed for cooking and
preparing meat in gravy or sauce, braised and
stewed meat, sauces, lightly fried vegetables,
frittatas and stewed dishes in general. Any other
use is considered to be improper.
Do not use the appliance as a fryer, the
temperature on the bottom of the pan exceeds
230°C, meaning oil could catch fi re.
Do not use the iron-bottomed appliance to cook
tomato sauces or particularly "acidic" foods.
At the end of each day, clean the well thoroughly in
order to prevent the formation of corrosive
deposits.
FILLING AND EMPTYING OF THE TANK
FILLING
Whit the pan lowered:
- Turn the thermostat knob to position " 100°C " .
- Press the water filler button on the control panel.
Fill the pan making sure the water level does not
exceed the maximum water level indicated.
EMPTYING
-
Use the handwheel (Manualmodel) or the switch
on the control panel ( motorizedmodel) to drain
the water.
BURNER IGNITION AND EXTINCTION
The thermostat control knob has the following
positions:
All manuals and user guides at all-guides.com
authorized by the
OFF
MINIMUM TEMPERATURE
INTERMEDIATE TEMPERATURES
MAXIMUM WATER TEMPERATURE
The gas valve control knob has the following
positions:
OFF
PILOT IGNITION
MAX. FLAME
PILOT IGNITION
- Turn the thermostat knob to position " 100°C " .
- Press and turn knob to "pilot on".
- Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
-
The pilot " ame can be seen through the peep hole
on the control panel.
MAIN BURNER IGNITION
- To light the main burner, turn the knob from "pilot
on" to "max. flame".
13