Toro Titan X4850 Manuel D'utilisation page 47

Figure 61
1. Wire form
2. Nut
7. Using a spring-removal tool (Toro Part No.
92-5771), remove the idler spring from the deck
hook to remove tension on the idler pulley and
roll the belt off the pulleys
WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
Figure 62
1. Idler pulley
2. Mower belt
3. Outside pulley
g334161
3. Idler pulley
(Figure 62).
g297456
4. Spring
5. Engine pulley
6. Spring-removal tool
8. Route the new belt around the engine pulley and
mower pulleys
9. Using a spring-removal tool (Toro Part No.
92-5771), install the idler spring over the deck
hook and place tension on the idler pulley and
the mower belt
10. Tighten the nut securing the wire form to the
idler pulley (Figure
Note:
Position the wire form against the idler
arm as shown in
11. Install the pulley covers.
12. Tighten the 2 bottom bolts holding the
mower-deck curtain to the mower deck; refer to
Releasing the Mower-Deck Curtain (page
45
(Figure 62).
(Figure 62).
61).
Figure 61.
36).