Alarm Output - Abus TVVR60011 Manuel Utilisateur

Settings
TAB Handling
Define the response in the case of an alarm:
Parameter Setting
Full Screen Mon- A message appears on the monitor.
itoring
Audible Warning The device emits a repeating tone.
Notify Surveil- Sends an alarm signal to a PC with
lance Center ABUS CMS software. The software
must be enabled and the recorder
set to surveillance mode on the PC.
Send E-Mail An e-mail is sent to a specific e-mail
address (see page 96).
see also page Fehler! Textmarke
Trigger Alarm
Output nicht definiert.
Confirm the settings by clicking Apply and leave the
menu with OK.
Note
To record with the aid of an alarm, you must set
up the schedule under Recording (see p. 109).
TAB PTZ
Parameter Setting
PTZ Select a PTZ camera
Open presets A preset (preset item) can be
opened
Preset Selects a preset
Start patrol A patrol can be started
Patrol Patrol selection
Start pattern A pattern can be opened
Pattern Pattern selection

Alarm output

1. Select an alarm output to be configured in the
drop-down menu under "Alarm Output No.".
Assign any name to the alarm output in "Alarm
2.
Name".
In "Dwell Time", select how long the alarm is trig-
3.
gered for.
In "Handling", select the schedule for the alarm
4.
output.
5. Click Copy to apply these settings for other alarm
outputs.
6. Confirm the settings by clicking Apply and leave
the menu with OK.
102