Settings; Setting The Camera Output - Abus TVHD80100 Notice D'utilisation

Live view

Settings

Note
The live view can be set as follows.
Open the main menu, then click on "Configuration". Then
click on "Liveview":
The following settings are available in the TAB "General":
Video Output In- VGA/HDMI
terface
Select the connection where the set-
tings are changed
Different camera layouts
Live View Mode
Switching time between the individu-
Dwell Time
al cameras and the sequence dis-
play
Allocate monitor for the output of
Event Output
events
in seconds, where the event on the
Full Screen
allocated monitor will be displayed.
Monitoring Dura-
tion
in seconds, the duration of the Pop-
Post Event Dis-
up window when an event occurs.
play Time
NoteVGA monitor connected:
A connected VGA monitor automatically becomes
the main monitor where the audio output is also
assigned.
No HDMI monitor connected
If during the boot process of the DVR the HDMI cable is not
connected, the main video signal is displayed at VGA output .
Connect the HDMI cable and reboot the DVR in order to dis-
play the main video signal at the HDMI output.
78

Setting the camera output

You can display a maximum of 8 cameras simultaneously
in the live view.
Click on the TAB "View".
1.
2. Select the display mode.

1 x 1

2 x 2

1 + 5

1 + 7

3 x 3
3. The camera signal is assigned to the corresponding
image section using the navigation keys.

"X" means that this camera is not displayed.
4. Click on Apply to accept the settings.