Publicité
8 Starting a Sampling Operation
The section describes how to use a setup configured using the E-CON3 Mode to start a Data
Logger sampling operation.
k Before getting started...
Be sure to perform the following steps before starting sampling with a Data Logger.
1. Connect the calculator to a Data Logger.
2. Turn on Data Logger power.
3. In accordance with the setup you plan to use, connect the proper sensor to the
appropriate Data Logger channel.
4. Prepare the item whose data is to be sampled.
k Starting a Sampling Operation
A sampling operation can be started when any one of the following conditions exist.
• After configuring a new setup with Setup Wizard
See step 8 under "To configure a Data Logger setup using Setup Wizard" on page 2-2.
• After configuring a new setup with Advanced Setup
See step 6 under "To configure a Data Logger setup using Advanced Setup" on page 3-1.
• While the E-CON3 main menu (page 1-1) is on the display
Starting a sampling operation while the E-CON3 main menu is on the display performs
sampling using the contents of the current setup memory area (which were configured
using Setup Wizard or Advanced Setup).
• While the setup memory list is on the display
You can select the setup you want on the setup memory list and then start sampling.
The following procedures explain the first three conditions described above. See "To recall a
setup and use it for sampling" on page 6-3 for information about starting sampling from the
setup memory list.
8-1
Starting a Sampling Operation
Publicité
