Publicité
5. If you plan to use a custom probe connected to CH1 of the Data Logger, specify
whether calibration or zero adjust should be performed. Perform one of the following key
operations to configure the desired setting.
To perform this operation:
Calibration of the CH1 custom probe
Zero adjust of the CH1 custom probe
No calibration
• The operation you specify will appear in line "F3:" of the program converter screen.
6. To password protect the program, press 4(
• This will cause the "Password?" prompt and password input field to appear under the
program name input field.
7. Enter up to eight characters for the password.
• If you change your mind about assigning a password, press J here. This will cause
the password input field to disappear and cancel password input.
8. After everything is the way you want, press w to convert the program in accordance with
the setup.
• The message "Complete!" appears when conversion is complete. To clear the message
and return to the screen that was on the display in step 1, press w or J.
7-3
Using Program Converter
).
Perform this key operation:
3(CALB) 1(CALIB)
3(CALB) 2(ZERO)
3(CALB) 3(None)
Publicité
