Becker 4935 200 032 0 Bulletin Technique page 8

Technical Information
2) Checking turning direction setting
Turning direction switch
Radio switch
Radio switch
Turning direction switch
3) Setting the end limits
Note
The turning direction of the drive must be correct. The lower end limit must always be
programmed fi rst.
There are 4 ways of setting the end limits for
roller shutters:
a) Lower position to upper position without end
stop
b) Lower position to upper end stop
c) Antilifting device in the lower end limit position
to upper position without end stop
d) Antilifting device in the lower end limit position
to upper end stop
Note
For the upper end limit, please ensure
that the roller shutter curtain is not
pulled out of its guide rails.
I
0
I
0
8
1. Move the mains switch from 0
to I.
2. Press the function switch.
If the shutter curtain moves in the wrong direction, the turning di-
rection of the drive must be changed. To do so, proceed as fol-
lows:
Move the turning direction switch
into the opposite position.
Note
If the turning direction cannot be changed, end limits
have already been stored. Delete both end limits and
recheck the turning direction of the drive.
There are 2 ways of setting the end limits for sun
protection systems:
a) Extended position to retracted position without
end stop
b) Extended position to retracted end stop
Action
3a) Lower position to upper position without end stop / Extended
position to retracted position without end stop
Note
No automatic curtain adjustment is carried out for this
end limit setting.
Adjust the mains switch from 0 to I.
Adjust to desired lower/extended
end limit using the function switch.
DE GB
Becker-Antriebe GmbH
35764 Sinn/Germany
The shutter curtain moves in the
desired direction
=> The turning direction is OK.
The turning direction has been
changed.
Recheck the turning direction.
Response
FR NL