Becker 4935 200 032 0 Bulletin Technique page 7

Technical Information
Industrial 868 MHz radio install
This installation set is to be used exclusively to set or commission Becker tubular drives with 868 MHz inte-
grated radio receiver (i.e. initial operation). After initial operation, the installation set must be removed.The
tubular drive has to be connected to the power supply. For information on how to install the drive, please
refer to the operating instructions for Becker tubular drives with 868 MHz integrated radio receiver.
Warning
The installation set is to be used in dry rooms only! Electrical connections must be made
by a qualifi ed electrician. Before installation, ensure that the power supply has been dis-
connected. All relevant regulations for electrical installation must be complied with.
Programme/delete end limits
Programming button
Deleting transmitter
1) Connecting installation set
Warning
When installing the drive, always ensure that the plug of the installation set is discon-
nected from the mains supply. All electrical work must be carried out by qualifi ed electri-
cians.
Installation set Motor cable
blue
N
black
L1
brown
green/yellow
PE
1. Connect connector cables of the drive to the installation set using
the cable colours as a guide (e.g. blue to blue).
blue
2. Ensure that the mains switch is in position 0 (OFF).
3. Insert the connector plug of the installation set l into the mains
black
supply.
brown
green/yellow
DE
Becker-Antriebe GmbH
35764 Sinn/Germany
Up / Retract
Function switch
Down / Extend
I
Mains switch
0
GB FR NL
7