Wayscral KS300 Notice D'utilisation page 79

Check that the pads are between 0.2 and 0.4 mm from the disc. If not, and if
you do not feel comfortable with this type of operation, contact a qualified
technician.
Never spray oil or any other lubricant on the disc or pads (e.g. when servicing
the chain or derailleur). If this happens, remove the grease from the pads and
disc or replace them.
Check the alignment of the pads by turning the wheel. Then you can hit the
road!
Disc: your scooter is fitted with disc brakes of 120 mm in diameter.
•
Brake pads are standard models, replace them when the friction material
is worn.
•
The reference of the brake pads fitted to your bike is as follows:
Remember that new brake pads must be broken in. They are broken in by riding
for a few minutes and alternating between sudden stops and light braking.
Replacing the brake pads
Remove the brake caliper by loosening the screws and remove the worn pads
from the caliper. The pads adhere to the brake caliper magnetically. You can then
simply use a small pair of pliers to take out each pad.
Insert each new pad one by one, they adhere magnetically to the brake caliper.
Correctly position the new pads so that the braking surfaces come into contact.
Model:
Bolids
Reference:
M05
79/192