Wayscral KS300 Notice D'utilisation page 63

Change the lock code of the scooter
•
Press the On/Off button for 3 seconds to start the scooter.
•
Enter the initial code to unlock the scooter
•
Press the On/Off button and the "-" button for 10 seconds to reset the
lock code.
•
The cursor moves to the first digit of the code. Its value can be
increased or decreased using the "+" and "-" buttons. Briefly press
the On/Off button to confirm and move to the next digit.
•
Press the On/Off button twice briefly to confirm the new code.
III. Control buttons
1. The control button panel is on the left side of the handlebars
2. On: press the On/Off button briefly to turn on the scooter.
3. Off: press the On/Off button for 3 seconds to turn off the scooter.
4. Lights: press the "+" button for 2 seconds to turn on/off the front
and rear lights
5. Speed modes: once in motion, press on the "+" or "-" button to change
the speed mode
•
L1: maximum speed 6 km/h,
•
L2: maximum speed 12 km/h
•
L3: maximum speed 18 km/h
•
L4: maximum speed 25 km/h
6. Pedestrian mode: press the «-" button for 3 seconds to put the scooter
in pedestrian mode (speed limited to 3 km/h). On the display, the number
"3" flashes and the tail light flashes every 3 seconds.
Do not press the accelerator lever at the same time as the
pedestrian mode to avoid the electric scooter starting up depending
on the speed mode chosen.
The pedestrian mode can be activated when the user has to walk next
to the scooter. Pedestrian mode reduces the effort required by
providing a speed of 3 km/h.
63/192