Wayscral KS300 Notice D'utilisation page 59

•
A nut and lock nut system on the brake lever allows you to adjust the
cable tension and so the braking force which will vary over time
depending on the wear of the brake pads.
•
Brake pads are standard, replace them when your pad no longer has a
friction component.
Remember that new brake pads must be broken in. They are broken in by riding
for a few minutes and alternating between sudden stops and light braking.
2. Changing the brake pads
Remove the wheel and remove the worn pads from the brake caliper. Position
the new pads in the caliper so that the braking surfaces come into contact. Do
not touch the braking surfaces. Insert the pads one after the other into the brake
caliper.
Then adjust the brakes as described in the previous paragraph.
C. How to use your KS300
•
Step 1: check that the silicone cover is covering the charging connector
and that your product is not damaged.
•
Step 2: unfold the scooter as recommended in section "III. Folding and
unfolding the scooter" and press the On/Off button. Enter the electronic
lock code defined in the paragraph "Electronic lock of the scooter".
59/192