Publicité
Les langues disponibles
Les langues disponibles
II.
Unpacking and assembling the scooter
1. Open the box and take out all the parts (do not throw away the
packaging as you will need it if you return the product)
2. Raise the stem by holding the handlebars.
3. Raise the folding lever and ensure that it is securely locked.
4. Insert the handlebars into the stem using the placement guides and the
cable connection device.
5. Place the holes of the locking hook opposite the holes of the stem and
handlebar.
6. Tighten the 2 screws (5 N.m) on each side using the 3 mm key provided.
7. Press the brake lever and insert the brake cable head into the brake lever
holder.
8. Pass the cable through the slot in the brake lever until the sheath reaches
the brake lever stopper. It is necessary to pull on the sheath to perform
the operation.
9. Check the brake's functioning by operating the lever. The brake caliper
must apply pressure to the brake disc to prevent the wheel from turning.
10. Follow steps 7, 8 and 9 for each brake lever. Check that the left lever
operates the front wheel brake system and the right lever operates the
rear brake system.
55/192
Publicité
