Worldcast Systems SOLAR FM Mise En Route page 4

English version
 Remove the ties to separate the cable from the frame
 Unscrew the side screws off the radome to be able to lift off the frame and transmitter. You
may feel a light resistance.
 Turn around the transmitter/frame block so the frame is on
the flat surface.
 Remove the 4 ties and 2 pins to be able to separate the
SOLAR FM from the binding frame.
2. Transmitter bench test (optional)

This step should be done before fastening the SOLAR FM to the pylon.
To be able to test the transmitter, the following settings will be applied:
 Transmitter power source: mains
 Audio signal: analog audio
 Operation mode: MANUAL
 Transmitter settings:
o Frequency: 98,00 MHz
o Power: 10 W
o MPX Deviation: 75 kHz
o AF deviation: 67.5 kHz
o Pilot deviation: 7.5 kHz
o Mode: stereo
4
All manuals and user guides at all-guides.com