Publicité
Les langues disponibles
Les langues disponibles
4.
Starting operation
4.1
Changing the material feed pump position
Be careful, as the moving parts of the swivel
mechanism can crush fingers and feet.
1. Grip handle (fig. 8, item 1) with one hand.
2. Push locking pin (2) with the other hand.
3. Swivel material feed pump up or down to the desired
position, until the locking pin (2) locks into the new position.
2
1
1. Transport position (fig. 9)
Transport unit only when the material feed pump is in the horizontal
position.
Swiveling the material feed pump to a horizontal position also allows
removal of the pump from the coating material container.
Ensure that the locking pin locks.
HC 950 • HC 970
GB
2. Operating position I (fig. 10)
Swiveling the material feed pump to a vertical position allows
the material feed pump to be immersed in the coating material
container.
3. Operating position II (fig. 11)
Swivel material feed pump to a slanted (45°) postion if using the
container suction system (accessory). In this position, there is open
space under the material feed pump.
35
Starting operation
Publicité
