Simons Voss Technologies PEGASYS 2.1 Guide Abrégé page 17

Electronic door fitting PegaSys 2.1 and 4.1 Back-to-
back
ü TX25 screwdriver at hand.
1. Remove any escutcheons and inner handles from
the inner side.
2. Shorten the spindle on the inside so that the total
length equals the door thickness +3 mm.
4
3. Optional: insert a round or profile cylinder into the
mortise lock from the inner side and fasten it with a
fastening screw.
4. Screw the mounting plate for the inner fitting onto
the outer fitting (TX25).
5. Insert the batteries into the battery box.
5
6. Insert the batteries into the inner fitting.
7. Attach the inner fitting onto the mounting plate.
6
8. Close the inner fitting towards the door.
9. If necessary, align the fittings with the installation
cylinder.
10. Fasten the inner fitting firmly to the mounting plate
(STX20).
7
8
11. Programme the fitting (e.g. with the demo card
set).
12. Open the fitting with an authorised card (e.g. from
the demo card set).
9
7. Replacing the battery (in-
tegrated battery com-
partment)
1. Insert the battery replacement key into the fitting.
10
9 Battery compartment loose.
2. Remove the battery compartment.
11
3. Remove the batteries.
4. Insert three new batteries.
5
5. Insert the battery compartment back into the fit-
ting.
13
9 Escutcheon flashes yellow, red, green.
EN
7. Replacing the battery (integrated battery compartment)
8. Technical data
Power supply

Battery

Up to 50,000 opening cycles, de-
pending on the following factors:

Battery life



Ambient conditions
-20 °C to +60 °C
Operating
Sharp temperature fluctuations have
temperature
an adverse effect on the service life
(*)
of the batteries.
Protection rat-
IP55 certified
ing (*)
Humidity (*) 95%, non-condensing
Radio emissions
13.553 MHz -
13.567 MHz
Only for item
< 42 dBµA/m (Dist. 10 m)
numbers:
NC.PG.ET.*,
PG.ET.*M*,
PG.ET.*L*
2.400 GHz -
2.4835 GHz
Only for item
< 10 mW
numbers:
PG.ET.*M*,
PG.ET.*L*
9. Declaration of conformity
The company SimonsVoss Technologies GmbH
hereby declares that the articles (NC.PG.ET.*,
PG.ET.*M*, PG.ET.BrPn*, PG.ET.*L*) comply with the
following guidelines:
PegaSys B 2.1: 3× AA alkaline or
lithium batteries
PegaSys S 2.1: 3× AAA alkaline or
lithium batteries
Reading system used
Design type
Installation conditions
Operating mode
17 / 32