Removing And Replacing The Extraction Tower And Emptying The Reservoir; Cleaning The Grease Filters And The Ventilation Tower Glass - Novy One Power Mode D'emploi

Clean the glass of the cooking plate
Wipe the surface clean with some washing-up liquid on a
damp cloth or sponge (it is best to do this after every use), then
dry the hob by rubbing with a dry cloth or with kitchen paper.
Always make sure that all cloths used are clean in order to avoid
scratching the surface.
In case of stubborn stains
Heavy contamination and stains (limescale stains, pearl-
like shiny spots) are best removed while the hob is still
warm. For this apply common cleaning agents and cleaning
methods. If this does not work well enough, you can use a
specific cleaning product for cleaning vitro-ceramic glass
(for example, Vitroclen)
Boiled-over food should first be soaked with a wet cloth; the
contamination residues should then be removed with a glass
scraper that is specially designed for ceramic hobs. After this,
clean the hob as described under "Cleaning glass hob".
Burnt-on sugar and melted plastics are best removed
immediately – while still hot – with a glass scraper. After this,
clean the hob as described under "Cleaning glass hob". Grains
of dirt/sand may fall on the cooking plate while peeling potatoes
or washing vegetables and may cause scratches when moving
the pans. Therefore, ensure there are no grains left on the
surface.
Discolouration of the hob does not have any influence on the
operation or strength of the vitro-ceramic. It is not a form of
damage to the hob, but it is a result of residues that have not
been removed and have therefore burnt-in.
Shiny spots occur as a result of wear caused by the base of the
pans, in particular when using cooking pans with an aluminium
bottom or when using the wrong cleaning agents. These can
only be removed with great difficulty using common cleaning
agents. If necessary, repeat the cleaning several times.
Due to the use of aggressive cleaning agents and scratching
caused by the pan bases, the glass surface is rubbed off over
the course of time, leaving dark stains.
Do not use the cooking plate as a table top or
for putting utensils on.
Always lift up the pans/pots and do not slide them along the
glass plate.
9.2 Removing and replacing the extraction
tower and emptying the reservoir
Water entering the suction opening is collected in a removable
reservoir (volume 150 ml).
– Press the button so the tower goes up.
– Hold the tower on both sides with 2 hands.

Do not pull up the tower only by the glass.
The 4 LEDs will flash as soon as the extraction tower is removed
from the suction opening. Do not place the extraction tower on
the hob.
1 Extraction tower
2 Removable reservoir
3 Fixed tank
4 Drawer
You will see the removable reservoir in the opening. Remove
and empty the container, clean if necessary. If this reservoir is
full, the fixed reservoir is filled. This can be dried with a cloth.
There is also a drawer on the bottom of the appliance. Water
can also collect here. Slide it out of the device to clean it.
After removing the reservoir:
– Place the removable container back into the suction opening.
– Return the extraction tower into the suction opening and
make sure it is sitting straight.
– Press the button and hold for 2 seconds.

INFO: All parts of the extraction tower, except the
uppermost glass, are dishwasher safe. g
9.3 Cleaning the grease filters and the
ventilation tower glass
After 20 cooking hours, the LED next to the
light up.
Remove the suction tower from the cooking plate as described
in section 6.2.
– 69 –
1
2
3
4
symbol will