Diono radian 3RXT Mode D'emploi page 30

HARNESS STRAP REMOVE/REPLACE
1. Remove harness straps from the metal hook on
back of seat.
2. Pull the harness straps out from the back of the
seat. Remove the harness pads and chest clip from
each side. Slide the harness strap out of the buckle
tongues.
3. Using a Phillips head screwdriver, take out the screws
and remove the access panel. Remove old harness
straps from each side of the seat.
4. Insert new harness strap through the slot and pull
the strap up.
5. Once the strap is pulled up until the metal "D"
ring is located as shown, re-fasten and close the
access panels in step 3.
6. Slide the new harness straps through the buckle
tongues, re-attach the chest clip and reinstall the
harness pads.
7. Slide the harness straps through to the back of the
seat and re-install them to the metal hook in Step 1.
58
1-866-954-9786
HARNESS STRAP REMOVE/REPLACE
1 2
3 4
5
diono.com
59