Important - Diono radian 3RXT Mode D'emploi

INSTALL USING 5-POINT HARNESS WITH
LAP/SHOULDER BELT: 2.3–22.7 kg (5–50 lb)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 30). The entire
seat bottom should sit flat on
the vehicle seat.
2. Thread the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
34
1-866-954-9786

3. IMPORTANT!

4. Test for tightness. Grab the
1
2
Tighten the
vehicle seat belt. Press down
firmly in the centre of the car
seat. To tighten, pull on the
loose end of the vehicle lap/
shoulder belt.
side of the seat where the
vehicle seat belt is and slide
the car seat side-to-side and
front-to-back. If the seat
moves less than 2.5 cm (1 in),
it is tight enough. Do not test
by grasping top or back of the
seat.
diono.com
3
4
35