Securing Your Child; Initial Setup - Diono radian 3RXT Mode D'emploi

SECURING YOUR CHILD

INITIAL SETUP

1. Place child in the seat. Make sure their back is
flat against the car seat back. This can be done in
or out of the car. Avoid bulky or heavy clothing
because they will prevent the harness straps from
being tightened properly at first fitment.
2. Place harness straps over child's shoulders and
legs and buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on each
buckle tongue to make sure it is securely attached.
3. Be sure the harness straps are at the proper height.
WARNING: All harness slot positions can be used
rear-facing, however, only use the top three
shoulder harness positions for forward-facing.
Rear-Facing
(harness AT or just below
shoulders)
52
1-866-954-9786
Forward-Facing
(harness just above
shoulders)
HARNESS SETUP
1. Loosen harness straps. Lift up on the harness
adjuster while pulling out on the harness straps
at the chest clip. Unbuckle the chest clip and the
centre buckle. Place harness straps off to the sides.
2. Place child in the seat. Make sure their back is
flat against the car seat back. Avoid bulky or heavy
clothing as they prevent the harness straps from
being tightened properly.
3. Place harness straps over child's shoulders and
legs and buckle. You will hear a "click" when
buckle tongues are securely attached. Pull up on
each buckle tongue to make sure it is properly
secured.
NOTE:
The addition or removal of clothing will change
the fit of the harness, especially bulky winter jackets.
Diono recommends harnessing your child first and
placing a blanket over them or putting their jacket on
backwards.
diono.com
HARNESS SETUP
53