Diono radian 3RXT Mode D'emploi page 24

4. Slide the vehicle seat belt
through the forward-facing
belt path and out the other
side. Buckle it. The seat belt
should lie as flat as possible
and not be twisted.
5. Tighten the vehicle seat belt.
Slowly pull the shoulder belt all
the way out and then let it go
back in. You will hear a clicking
sound as the belt retracts.
Slowly pull out on the belt
and it should be locked. If not,
please review your car's owner
manual.
Press down firmly in the centre
of the car seat. To tighten, pull
from the shoulder belt on the
side nearest to the buckle
while feeding the slack back in
the retractor.
46
1-866-954-9786
6. Tighten the top tether strap.
4
7.
5
Push the car seat back while
tightening the tether strap to
remove all the slack.
Test for tightness. Grab the
side of the seat with one hand
where the seat belt strap is and
slide the car seat side-to-side
and front-to-back. If the seat
moves less than 2.5 cm (1 in),
it is tight enough. Do not test
by grasping top or front of the
seat.
diono.com
6
7
47