Diono radian 3RXT Mode D'emploi page 19

INSTALL USING 5–POINT HARNESS WITH
LAP BELT: 2.3–22.7 kg (5–50 lb)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 30). The entire
seat bottom should sit flat on
the vehicle seat.
2. Thread the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
36
1-866-954-9786
3. Tighten the vehicle seat belt.
4. Test for tightness.
1
2
Press down firmly in the centre
of the car seat. To tighten, pull
on the loose end of the vehicle
lap belt.
Grab the side of the seat
where the vehicle seat belt is
and slide the car seat side-to-
side and front-to-back. If the
seat moves less than 2.5 cm
(1 in), it is tight enough. Do not
test by grasping top or back of
the seat.
diono.com
3
4
37