Stahl 8571/21 Serie Mode D'emploi page 23

Les langues disponibles

Maintenance, Overhaul, Repair

10.1 Maintenance

• Consult the relevant local and national regulations to determine the type and extent of

inspections.

• Tailor inspection intervals to the operating conditions.

At a minimum, check the following points during maintenance on the device:

• Whether the conductors have been clamped properly

• Whether the enclosure, seals and surface are damaged

• Whether there is dirt in the sockets

• Whether the permissible temperatures are complied with (according to UL 60079)

• Whether it is used as intended

10.2 Overhaul

Overheating and explosion hazard due to defective switching contacts!

Non-compliance results in severe or fatal injuries.

• Replace the complete socket flange after each short circuit in the

Observe the relevant national regulations in the country of use.

10.3 Repair

Explosion hazard due to improper repair!

Non-compliance results in severe or fatal injuries.

• Repair work on the devices must be performed only by

Explosion hazard due to improper repair!

Non-compliance results in severe or fatal injuries.

• Hermetically sealed connections are to be repaired only in

• Repairs are not permitted.

294386 / 8571661300

2022-08-08·IO00·III·en·00

main circuit of the switch because the state of the switching

contacts cannot be checked in hermetically sealed equipment.

R. STAHL Schaltgeräte GmbH.

accordance with the manufacturer's description.

Maintenance, Overhaul, Repair

DANGER

SolConeX

Receptacle, 30 A

8571/21 series