Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Controls
The hood is operated using the (5) push-but-
tons located on the right side of the hood.
The light switch turns the halogen lights on
and off. Push the light switch once to turn the
lights ON - push a second time to turn the
lights ON to a brighter level - push a third
time to turn the lights OFF.
The blower on-off / speed 1 switch turns
the blower on to its lowest running speed.
To turn OFF the blower, push in and hold
this blower switch for approximately 2
seconds.
The blower speed 2 switch turns the blower on to medium-low running speed.
Pressing this switch a second time sets a timer which keeps the blower operating at
this speed for 10 minutes. The LED will blink during this time and the blower will shut
off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is high.
After every 30 hours of operation, the LED above the "blower speed 1 switch" will
be illuminated (RED) and blink for 30 seconds after turning off the blower. This is a
reminder to clean the grease filter. Once the grease filter is cleaned and installed,
press in and hold the "light switch" button for approximately 2 seconds during the
blink of the LED.
HALOGEN BULBS
This range hood requires two halogen bulbs
(Type T4, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Loosen the ring nut by turning it
counterclockwise.
2. Remove the bulb by pulling sideward - DO
NOT ROTATE. CAUTION: BULB MAY BE
HOT!
3. Replace with Type T4, 12 volt, 20 watt halogen bulb. Do not touch replacement
bulb with bare hands!
LED
- 9 -
BLOWER
SPEED 4
BLOWER
SPEED 3
BLOWER
SPEED 2
BLOWER
ON-OFF /
SPEED 1
LIGHT
SWITCH
RING NUT
Publicité
