EUROM EK1999 Manuel D'utilisation page 31

Location and connection
Remove all packaging material and keep out of reach of children. After removing

packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
Check if the control switch is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V~50Hz earthed

socket. To prevent the circuit overloading, check that no other appliances are
connected to the same group.
Set-up and operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far as
it goes). With the mode selector dial, adjust the heater to suit your preferences.
Once the temperature in the area being heated has reached the right level, slowly
turn the thermostat dial anticlockwise until you hear a soft click; leave the dial in that
position. The heater will automatically maintain the temperature at this level. It does
this by switching the heating elements off and on when the temperature rises or falls
too much. The thermostat dial is continuously adjustable. A higher temperature is
set by turning it clockwise; a lower temperature by turning it anticlockwise.
Safety features
Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off.
If this occurs, immediately turn the mode selector dial to O, unplug and allow heater
to cool down for at least 10 minutes. In theory, the heater can now be used as
normal. There is, however, generally a reason for an appliance overheating. This may
be because the heater cannot adequately release its heat or take in fresh air (because
the heater is covered, the grills are blocked, the heater is placed too near a wall
etcetera). Before using the heater again, therefore, remove or adjust whatever
caused the appliance to overheat. If you cannot find the cause and overheating
recurs, stop using the heater and contact your vendor or a certified electrician for
inspection/repair. Overheating poses a serious fire risk!
31