EUROM EK1999 Manuel D'utilisation page 30

fallen or shows any other signs of damage. Remove the plug from
the socket immediately. Take the entire device back to your
supplier or a recognised electrician to be checked and/or repaired.
Always ask for original parts to be used.
4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
EUROM EK heaters are 'real space' heaters, with a powerful fan which disseminates
a great deal of air. Cold air is sucked in at the back, heated, and then blown out as
hot air. Because a relatively large quantity of air is sucked in and blown out, the air
expelled by the heater does not feel particularly hot. As a great deal of air is heated
and blown out, however, the entire space (not just the air around the heater!) is
gradually warmed up.
Control panel
The control panel consists of two dials:
* The mode selector dial with 4 positions is located on the left.
From top to bottom:
* The continuously adjustable thermostat dial is located on the right.
- O or off
- fan only
- 1000W power (low)
- 2000W power (high)
30