Ferplast STAR Série Manuel D'utilisation page 12

STAR AQUARIUMS
IT
6 PROFILE IN ANODIZED ALUMINIUM
The structure is made with special EN AW-6060 15 micron anodized
aluminium alloy profiles, in order to ensure greater resistance to wear, also
in the case of marine environments (saltwater).
EN
7 AUTOMATIC PISTONS
Special automatic pistons facilitate the opening of the lid. These have been
treated so that they are also resistant to salt water.
8 FRONT HATCH
Each fish tank has a practical and easy-to-open front hatch.
FR
9 TOP COVER
Top cover completely hinged to the upper frame.
10 SUCTION GRILLS
All rear ventilation grills are provided with an adjustable opening.
D
11 SIDE HATCHES
Practical side hatches enable to add further accessories such as skimmers,
etc.
12 PRESET FOR INTERNAL AND EXTERNAL FILTERS
NL
Preset for passage of internal filters BLUWAVE and/or external filter tubes
BLUEXTREME.
13 PRESET FOR AUTOMATIC FOOD FEEDER
Preset for CHEF food feeder positioning by removing a ventilation grill.
ES
AQUARIUM SOFTWARE
The AQUARIUM SOFTWARE INTERACTIVE CD-ROM, specifically developed
by a team of Ferplast experts, will help to install a freshwater or marine
aquarium without making mistakes. The software is divided into three
parts and is constantly updated and expanded at each edition. Apart from
helping to choose favourite fish, it enables to receive information on any
SK
incompatibility among species and finally offers practical advice on how
to resolve many possible inconveniences encountered when installing and
maintaining an aquarium.
INSTALLING THE AQUARIUM
CS
After correctly positioning the aquarium, by strictly following the
instructions set forth in "Preliminary warning", proceed with the STAR
aquarium installation and start-up.
• Insert the lamps provided with the aquarium in the specific lamp holders,
after positioning the relevant ring nuts. Then fix the ring nuts to the lamp
HU
holders and turn the lamps sideways 45 degrees (Fig. 14).
• Fix the thermometer (Fig. 15) to the fish tank where it is clearly visible.
• Furnish the aquarium according to your taste (your local aquarium shop will
be able to help and advise you).
• In any case, if you are furnishing your aquarium with freshwater tropical
fish, we advise you to spread a thin and even layer - no more than 5mm - of
SV
fertilizer (Fig. 16) on the bottom of the fish tank and then cover the layer
with gravel. Overall thickness should not be lower than 4 cm. Fill the fish
tank with water (we advise you to use 50% tap water and 50% demineralised
water for aquariums, although this percentage may vary according to the
characteristics of your tap water).
• Install the external filter by strictly following the instructions reported in the
DA
relevant user's manual (including the use of BLUSTART capsules (Fig. 17) at
filter STARt-up). We advise you to position the suction and delivery tubes in
the 2 rear angles of the aquarium and to use the two removable grills for
the passage of these tubes. If you have purchased the STAR 200 aquarium,
which has 2 external filters, we advise you to place the 2 suction tubes in the
2 rear angles and the 2 delivery tubes in the centre of the fish tank.
RU
• Fix the BLUCLIMA heater to the inner side of the fish tank, using relevant
clips and suckers, in a place where the heater comes into contact with a
generous flow of water (for example, near filter delivery).
• Set the heater temperature depending on the plants and fish species chosen
(for example, for fresh water tropical aquariums, average temperature is
around 25-26 °C).
PL
• Arrange the plants in the aquarium 24h after filling the fish tank with
water, so that the temperature and the chemical values of the water are
stabilized.
12
9
11
13
15
10
12
14
16