Installing Side Rails; Verso Ii Side Rail; Diana Side Rail - Invacare Sonata Manuel D'utilisation

Lit
Masquer les pouces Voir aussi pour Sonata:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 53
1.
Place the bracket on the cross tube.
2.
Insert the bolts and tighten the nuts.
Height adjustable legs
The legs can be adjusted in 3 different heights with a pipe
pin. Ensure the pipe pin is fully inserted through both holes
and that the pipe pin is completely locked. Make sure that
all four legs are adjusted to the same height.

3.6 Installing side rails

WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling the side rail.
– Pay attention to your fingers.
– Follow instructions carefully.
– After each assembly, check that all fittings are
properly tightened and that the side rail has
the correct function.
Removable 3/4 length side rails
WARNING!
Risk of entrapment
There's a risk of entrapment or suffocation
between mattress support, side rail and bed end.
– When using removable side rails, always make
sure that the distance between the bed end
and the side rail's handle upper edge is less
than 6 cm in the head end and more than 32
cm in the foot end of the bed.
1574228-E

3.6.1 Verso II side rail

Mounting
The mounting of the side rail must be done with the
side rail in locked position.
1. Place both brackets of the side rail on the frame of the
bed, with the locking button A facing towards the foot
end of the bed.
2. Ensure that the bracket near the head end of the bed is
placed encompassing the lifting pole support as shown
in detail B.
3. For beds equipped with bed ends with Sanne style
fitting, it is beforehand necessary to temporarily
disengage the locking pin C from the head bed end
to place the bracket.
a. Pull the locking pin C and rotate 1/4 turn to lock it
in the disengaged position.
b. Position the bracket under the locking pin as
described in step 2.
c. Rotate the locking pin and allow it to engage with
the bed end.
4. After the brackets are positioned correctly on the frame
of the bed, fix the side rail by firmly tightening the
finger screws D.
Dismounting
1. Untighten the finger screws and lift the side rail of the
bed frame.

3.6.2 Diana side rail

Compatibility
WARNING!
– The Diana side rail cannot be used on Sonata
beds, when the bed is configured with
adjustable legs without castors and when the
legs are mounted in the lowest height.
Setup
11

Publicité

Table des Matières
loading

Table des Matières