Publicité
CDI MAGNETO AND STARTER CLUTCH
b
1
a
a
2
E
(TT-R125E/TT-R125LWE)
2
NOTE:
G
G
NOTE:
Caulk a the end of the starter clutch holding
bolt near its outer diameter to serve as a stop-
per.
1
3
NOTE:
G
G
G
NOTE:
Tighten the nut (magneto) while holding the
magneto with a sheave holder 3.
4 - 64
3. Install the starter clutch 1 on the rotor 2.
Install the starter clutch with its plate portion
a facing the rotor.
Insert the plate portion of the starter clutch
so that it is flush with the surface of contact
b with the rotor.
4. Tighten:
Bolt (starter clutch)
G
30 Nm (3.0 m · kg, 22 ft · lb)
5. Install:
Starter wheel gear 1
G
Woodruff key 2
G
Rotor 3
G
Clean the tapered portion of the crankshaft
and the magneto hub.
When installing the magneto rotor, make
sure the woodruff key is properly seated in
the key way of the crankshaft.
Apply the engine oil on the starter wheel
gear inner circumference.
6. Install:
Plain washer 1
G
Nut (magneto) 2
G
80 Nm (8.0 m · kg, 58 ft · lb)
Sheave holder:
YS-1880-A/90890-01701
ENG
Publicité
