WAGNER W 560 Manuel D'utilisation page 23

W 560
9) Turn off the machine and rmove the plug.
10) Screw of the container and empty it. Pull out the suction tub with container seal.
11) Pull the ventilating hose (Fig.10 A) at the top from the gun body. Screw off
the valve cover (14). Remove the diaphragm (15). Clean all the parts carefully.
12) Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
CAUTION!
13) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap and nozzle
with a brush and solvent or water..
Assembly
The unit may only be operated with an integer diaphragm (Fig. 10 A, item 15). Place the
diaphragm with the pin facing upwards on the bottom section of the valve. Also see
the marking on the gun body. Place on the valve cover and screw it closed. Place the
ventilating hose on the valve cover and on the nipple at the gun body.
Slide the nozzle seal (Item 4) with the groove (slot) facing forwards into the nozzle
(Fig. 10 B). Put the nozzle onto the gun body and fi nd the correct position by turning it.
Put the air cap onto the nozzle and tighten it using the union nut.
Place the container seal from below on the suction tube and slide it over the collar, while
turning the container seal slightly. Insert the suction tube with container seal in the gun
body.
Maintenance
WARNING! Never operate the machine without the air filter; dirt could
be sucked in and interfere with the function of the machine.
•
Change the air fi lter if it is soiled (Fig. 9). The smooth side of the air fi lter must be placed
towards the machine.
•
In order to mount the gun more easily apply lubricating grease (enclosed) liberally to
the O-ring at the gun front part. (Fig. 10, Item 5)
Accessories
An additional container with a top makes changing colours easy. The top prevents the
paint from drying out and the evaporation of solvents.
Never clean seals, diaphragm and nozzle or air holes of the
spray gun with metal objects.
GB
17