EUROM EK3001 Manuel D'utilisation page 35

Control panel EK3001
The EK3001 control panel consists of two dials:
 The mode selector dial with 4 positions is located on the left.
From top to bottom:
 The continuously adjustable thermostat dial is located on the right.
Location and Connection
 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 Make sure the heater is switched off (switch to O position), then plug into a
correctly functioning 230V-50Hz socket. Only connect the heater to an earthed
socket!
Set-up and Operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far
as it goes). With the mode selector dial, adjust the heater to suit your preferences.
Once the temperature in the area being heated has reached the right level, slowly
turn the thermostat dial anticlockwise until you hear a soft click; leave the dial in
that position. The heater will automatically maintain the temperature at this level.
It does this by switching the heating elements off and on when the temperature
rises or falls too much. Note! After the thermostat has switched the heating
elements off, the fan will keep turning. This means that the air is constantly moved,
allowing the heater to accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by
turning it clockwise; a lower temperature by turning it anticlockwise.
- O or off
- fan only
- 1500W power
- 300W power
35