Télécharger Imprimer la page

Krups Aroma Partner KM760D10 Mode D'emploi page 18

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
GROUND COFFEE CONTAINER
„ Open the ground coffee container's lid. Fig. 3. Fill the container with ground
coffee. Do not exceed 400g. Fig. 4.
TIP: To well conserve the ground coffee, keep it at room temperature in the
ground coffee container, away from humidity and light.
The ground coffee can loose its aroma if it's not well protected. We advise you
to use the amount of coffee equivalent to your consumption over the coming 2-3
days and to choose 250g bags.
„ If you accidentally pour ground coffee into the water tank, do not start the cycle.
Clean the tank, otherwise the coffee may block the water circuit.
„ Close the ground coffee container lid.
„ Open the water tank lid (C). Fig. 5.
„ Fill the carafe (L) with cold or water at room temperature, then pour it into the
water tank (F). Fig. 6.
„ The number of cups is shown by the markings on the carafe and by the water
level indicator on water tank. Do not exceed 10 cups. Fig. 6.
IMPORTANT: Please note that the coffee machine doesn't automatically dose the
water according to the number of cups set for the coffee dosage.
„ Place the carafe (L) onto the heating plate (H), make sure that it is properly
positioned so as to activate the coffee pouring mechanism.
MAKING COFFEE BY USING THE GROUND COFFEE STORAGE BOX
„ Insert a permanent filter or a paper filter into the filter holder (J). If using a paper
filter, fold the bottom of the filter to make sure it is fully open and properly
positioned in the filter holder. Fig. 8.
„ IMPORTANT: Make sure the paper filter is againt right side of filter holder.
„ Make sure that the filter holder (I) is well inserted.
„ Select the number of cups desired by pressing the CUP SELECTION button
(7) Fig. 8. It will automatically be set after 3 seconds, or by pressing the START
button (9).
„ Select coffee strength desired by pressing the COFFEE STRENGTH button (8)
before starting the cycle. Fig. 10. It will automatically be set after 3 seconds, or
by pressing the START button (9)
NOTE: These two parameters will measure the ground coffee quantity based on
your selection.
„ Make sure there is enough coffee ground in coffee box.
„ The "press lever" indicator will blink. Press the lever to automatically pour
ground coffee into the filter (J). Fig. 10. Press the lever until the selected cup
quantity appears on the screen.
„ The START button blinks, press the START button(9) to start the cycle. Fig. 11.
„ The appliance beeps 3 times at the end of brewing cycle.
18
MAKING COFFEE

Publicité

loading