Krups Aroma Partner KM760D10 Mode D'emploi page 17

„ The power cord must never be close to or in contact with the hot parts of your
appliance, near a source of heat or over a sharp edge.
„ For your safety, only use the manufacturer's accessories and spare parts
designed for your appliance.
„ Do not pull on the cord to unplug the appliance.
„ Never put your coffee jug in a microwave oven, on a flame or a electric cooking
plates.
„ Do not fill the appliance with water if it is still hot.
„ All appliances are subject to strict quality control procedures. These include
actual usage tests on randomly selected appliances, which would explain any
traces of use.
„ Always close the lid when running the coffee maker.
„ Do not brew coffee if the carafe already has coffee in it.
„ To prevent any overflow, the carafe must be placed on the heated base of the
coffee maker, otherwise there could be some overflow of hot water or hot coffee.
„ The coffee maker becomes very hot during the infusion cycle. Please handle it
with care.
„ Do not disassemble the appliance.
„ Do not use the jug without the lid.
„ Do not pour hot water in the tanks.
„ The coffee-maker shall not be placed in a cabinet when in use.
BEFORE FIRST USE
„ Place the coffee maker on a hard-flat surface.
„ Connect the power cord to a 220V-240V wall socket.
„ Remove stickers from your coffee maker.
„ Before using your coffee maker for the first time, run a cycle without coffee to
rinse the circuit. Fill the water tank to the maximum level and start a cycle by
pressing the START button (9).
„ IMPORTANT: your machine has been designed to work with cold or water at
room temperature only.
SETTING THE CLOCK
„ When you plug in the coffee maker for the first time, « 12:00 am » will start flashing
on the display. Fig. 1. Set the time by pressing the HOURS button (2) to set the
hours and the MINUTES button (3) to set the minutes. Fig.2. The time will appear
on the display. It will be automatically set after 10 seconds or by pressing the
following buttons: Preset time button(5), CLOCK button(4), START button (9).
„ NOTE: Your clock is now set and will continue to show the time, even when your
machine is in standby mode. If you want to set the time again, press the CLOCK
button (4). Then, repeat the steps above to reset the clock.
BEFORE FIRST USE
17