Publicité
Les langues disponibles
Les langues disponibles
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct
sunlight in out-buildings or terraces/outside seating areas. If you are placing your
appliance in an out-building such as a garage or annex ensure that it is placed above
the damp course, otherwise condensation will occur on the cabinet. Never place the
appliance in a wall recessed or into fitted cabinets or furniture when it is working,
the metal grid at the back may become hot and the sides warm.
This refrigerating appliance is not intended to be used as a built-in appliance.
Recommendation combination:
The following combination of drawers, baskets, and shelves is recommended for
energy to be used as efficiently as possible by the refrigeration unit.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be affected
and may cause a malfunction. Once the appliance is placed in its final location, adjust
the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then
rinse with warm water using a damp sponge or cloth. Wash the baskets and shelves
in warm soapy water and dry completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the
appliance. DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE
APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait
30 minutes before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it
is working properly and to allow it to reach the correct temperature.
26
Publicité
