Teac VRDS-701T Mode D'emploi page 22

Settings (continued)
Automatic power saving function
This unit has an automatic power saving function.
o The automatic power saving function is ON when the unit is
shipped new from the factory.
MENU
AUTO POWER SAVE
ON
OFF
The automatic power saving function is disabled.
ON
The unit will automatically enter standby mode if no audio is out-
put and no operation is conducted for about 30 minutes.
o The automatic power saving time setting can be used to change
the amount of time until the unit enters standby mode.
Automatic power saving time setting
This sets the amount of time until the automatic power saving func-
tion causes the unit to enter standby.
MENU
APS TIME SETTING
30 [MIN]
This can be set in a range from 1–255 minutes in 1-minute incre-
ments (30 minutes by default).
MQA
This sets the MQA decoding function.
MENU
MQA
ON
OFF
MQA decoding will not be used.
ON
Only core decoding will be conducted. The output will be at
twice the sampling frequency (88.2 kHz).
22
Power on playback function
Playback can start automatically when the unit is turned on.
MENU
POWER ON PLAY
OFF
OFF
Playback will not start automatically when the unit is turned on.
ON
Playback will start automatically when the unit is turned on.
Shuffle and random playback
Shuffle and random playback modes can be selected.
MENU
SHUFFLE_RANDOM
SHUFFLE PLAY
SHUFFLE PLAY
This plays each track on the disc once.
o Unless repeat has also been set, playback will stop after all
tracks on the disc have been played.
RANDOM PLAY
This plays the tracks on the disc randomly.
o Regardless of the repeat setting, playback will not stop until
the stop (8) button is pressed.
Program playback track input behavior
This sets what happens when the number buttons are used during
program playback.
MENU
PROGRAM PLAY
PLAY LATER
PLAY LATER
The input track number is added to the end of the program.
The track that is playing continues to play.
PLAY NOW
The input track number is added to the end of the program and
starts playing immediately.