Teac VRDS-701T Mode D'emploi page 13

A
12V TRIGGER connectors
Use these to control power from an external source.
Do not connect anything to these connectors when not using
them (page 14).
Use commercially-available mono mini plug cables for
connections.
B
UPDATE (maintenance) port
This is used for maintenance. Do not connect anything to this
port unless instructed to do so by our service department.
C
COAXIAL/OPTICAL digital audio output connectors
Use these to output digital audio. Connect digital audio input
connectors of audio devices here.
Use commercially-available RCA coaxial digital cables or
rectangular optical digital cables for connection.
D
CLOCK sync input (10MHz IN) connector
Use this connector to input 10MHz clock synchronization signals
(page 25).
Use a commercially available BNC coaxial cable for
connection.
E
Power inlet (~IN)
Connect the supplied power cord here.
After all other connections are complete, connect the
power cord's plug to a wall outlet.
V
Do not use any power cord other than the one
included with this unit. Use of other power cords
could result in fire or electric shock.
V
Disconnect the power plug from the outlet if you
will not use the unit for a long time.
EN
13