Teac VRDS-701T Mode D'emploi page 14

Connections (continued)
Synchronizing external devices with
power operations of this unit (trigger
function)
The power of a connected D/A converter or another device that
supports trigger functions can be synchronized with the power
operations of this unit.
Use commercially-available mono mini plug cables for connections.
12V TRIGGER connectors
OUT
When this unit is turned on, it outputs 12 V.
By connecting this unit's TRIGGER OUT connector to a power
amplifier, subwoofer or other device that supports trigger
input, the power supply of that device can be synchronized
with the power operations of this unit.
IN
Connect this to the trigger output connector of a preamp or
other device.
This will make the power operation of that preamp or other
device control this unit, putting it in standby and turning it on.
VRDS-701T
14
ATTENTION
o To use the trigger input function, set this unit's STANDBY/ON
switch to ON.
o When connecting both IN and OUT, be careful not to cause a
trigger loop in the entire system.
Device that supports trigger input
(e.g., UD-701N or D/A converter)
Mono mini plug cable