Publicité
Les langues disponibles
Les langues disponibles
power and same characteristics.
› It is advisable to contact a Crippa
Campeggio technician before
fixing any screws or nails on the
walls in order to avoid damaging
the electrical apparatus.
NEVER COVER THE
EQUIPMENT!
HEATING: INSTRUCTIONS TO
ADOPT FOR USE
OF THERMOCONVECTORS/
ELECTRIC FAN HEATERS
If the house inside will be equipped
with electric heaters it is important
to take the following precautions.
66
› Periodically check the cavities,
ventilation and cooling grids. In
fact these factors, if neglected,
could lead to fire risks.
› We also remind you that the
stoves must remain well anchored
to the wall, as portable heating
devices in this type of structure
are prohibited.
AIR-CONDITIONER
› If a conditioner or air conditioner
has been installed on your Mobile
Home, please read the instructions
in the enclosed use/maintenance
manual carefully.
› All appliances supplied will be
of primary brand with European
warranty; for information on the
same, we refer to the individual
warranty-use/maintenance
booklets attached to this
document.
M O B I L E
H O M E
ELECTRICAL SYSTEM
MAINTENANCE
To keep the electrical system
efficient over time it is necessary to
carry out the following operations.
› Press the "test" button of the
differential switch once a month.
› Review every two years the
earthing and protection system.
› Check the power cable for
corrosion or cuts in the main
insulation.
IMPORTANT NOTE
› The power supply panel of the
Mobile Home has been sealed so
that there are no changes that
could compromise the safety of
the electrical system.
› Crippa Campeggio declines all
responsibility to things and people
if this seal is removed or tampered
with. If for any reason it will be
necessary to intervene to replace
any faulty switches, the user must
contact us to make these changes.
GAS DISTRIBUTION
The gas system was checked at
the factory by the manufacturer,
however it is absolutely necessary
to be checked and tested by an
expert before putting it into
operation for the first time at the
location.
M A I N T E N A N C E
A N D
U S E
M A N U A L
IMPORTANT
Before connecting the gas supply,
consult the data on the label to be
sure of the type of gas to be used.
PREPARED FOR GAS
METHANE
GPL
CAUTION: For the supply with the LPG gas cylinder install
the pressure regulator which has the capacity 60Kg / h
outlet 30 mbar.
PREPARED FOR GAS
METHANE
GPL
CAUTION: For the supply with the LPG gas cylinder install
the pressure regulator which has the capacity 60Kg / h
outlet 30 mbar.
Prepared for methane gas.
Prepared for GPL gas
>>> we recommend to use the gas pressure
regulator with a flow rate of at least 2.6 Kg/h.
67
Publicité
