Télécharger Imprimer la page

Echo DCS-5000 Mode D'emploi page 29

Masquer les pouces Voir aussi pour DCS-5000:

Publicité

Les langues disponibles

Les langues disponibles

DCS-5000
Sap from palm trees may corrode metal parts unless proper saw
maintenance is performed. Make sure to clean metal parts from palm
sap immediately after use.
Remove sprocket guard. Clean wood chips and sawdust from guard and
motor.
Never use metal tools for cleaning which can scratch the metal paint and
allow corrosion to develop.
Clean sap accumulation from metal parts with cloth and warm water with
soap.
Rinse with clean water and dry metal surfaces.
Apply a light coating of engine or bar and chain oil to metal parts after they
are cleaned.
Install and properly tension guide bar and chain. Run motor for one minute
alternating motor speed between maximum RPM for 5 seconds and stop
for 5 seconds to coat metal parts with additional protective chain oil.
◆ Keep chain properly tensioned during operation to prevent
the chain from jumping out of the guide bar rail slot and
damaging motor parts.
Felling a Tree
A falling tree can seriously damage anything it may hit a car, a
house, a fence, a power line, or another tree. There are ways to
make a tree fall where you want it, so first decide where that is!
99922238004
© 01/2023 ECHO Incorporated
OPERATION
29

Publicité

loading