Corradi Eteria Manuel D'utilisation page 15

DECLARATION OF PERFORMANCE - REGULATION (EU) No 305/2011
No: DoP_ALBA-ETERIA_2016.05_(ENG)
1. Unique identification code of the product-type: ALBA and ETERIA (Registered international trademark n. 1052325)
2. Type, batch or serial number or any other element allowing identification of the construction product as required pursuant to Article 11(4):
see CE of the User Manual
3. Intended use or uses of the construction product, in accordance with the applicable harmonised technical specification, as foreseen by the manufacturer:
Systems for outdoor covers for the protection from sunlight and rain
4. Name, registered trade name or registered trade mark and contact address of the manufacturer as required pursuant to Article 11(5):
CORRADI Srl - via G. Brini, 39 – IT-40128 Bologna (Italy)
5. Where applicable, name and contact address of the authorised representative whose mandate covers the tasks specified in Article 12(2): NPD, not applicable
6. System or systems of assessment and verification of constancy of performance of the construction product as set out in Annex V of CPR: Process 4
7. Not applicable
8. Not applicable
9. Declared performance: The product meets the basic requirements defined in the standards mentioned below if used correctly.
Product
ALBA Resistance to wind forces
ETERIA
Solar factor with Eclissi canvas (gtot)
(*) INDICATION / CONDITIONS TO WHICH THE USAGE OF THE PRODUCT IS SUBJECT: The CORRADI product is subject to the installation activity done for the Client.
The following CE Declaration of Performarce is subordinated to the observance of constraints and indications in the product warranty, as well as the correct installation done by the person in charge in accordance with the
installation and lay-out instructions established by CORRADI Srl.
The Authorized Installer has to draw up and hand over the suitable DECLARATION OF CORRECT INSTALLATION AND CLASSIFICATION OF WIND RESISTANCE to the user, which testifies the correct installation, in accordance with
the instructions supplied by the manufacturer and applied in accordance with the state and morphology of the installation site and corresponding to the using conditions for which it has been realized.
The Installer has to follow the reference instructions in the "INSTALLATION MANUAL" and "USER MANUAL" .
The Installer fills out and signs the DECLARATION OF CORRECT INSTALLATION AND CLASSIFICATION OF WIND RESISTANCE.
(**) VALID UNLESS OTHERWISE NOTED IN THE DOCUMENT "ORDER CONFIRMATION"
10. The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 9.
This declaration of performance is issued under the sole responsibility of the manufacturer identified in point 4.
Signed for and on behalf of the manufacturer by:
Corradi Srl
CEO
Ir. Arch. Raf Segers
Rev. 0 - 05.2016
Key characteristics
MANUALE UTENTE I USER MANUAL I MANUEL D'UTILISATION I BENUTZERHANDBUCH
Performance
Class 2 (*) (**)
See document "Bioclimatics gtot" (**)
Bologna (Italy), 19 May 2016
Harmonized technical specification
EN 13561
15 di 20