SAMES KREMLIN SEGUIN 3000 Manuel D'utilisation page 90

Disassembly / Reassembly Operation
Disassembly of the pump
Lower valve
Wet cup seals
Piston head
40
 Unscrew the 2 nuts (16) and put aside the flange (1), the tie
rods (10) and the protection (4),
 Clamp the pump horizontally through the body with a vice
(7),
 Unscrew the foot-valve body assembly (23) taking off if
necessary the washer (25),
 Take off the piston (11) downwards,
 Put aside the cylinder (21).
 Push the ball (19) to remove the spacer (18),
 Take off the seat (20), the seal (22) and the pin (24),
 Put aside the seal (9),
 Clean the parts, check them if they are damaged or worn.
 Reinstall the parts in the reverse order of the disassembly
sequence.
 Unscrew the wetting cup nut (5),
Take off the washers (6 & 13),

Put aside the seals,

Clean the parts, check them if they are damaged or worn.

 Reinstall the parts in the reverse order of the disassembly
sequence.
 Unscrew the seat (17),
 Take off the ball (15), the washers (6 & 13) and the seals (14),
 Clean the parts, check them if they are damaged or worn.
27/10/2020 582131110-2B0225-indA-EN.docx