Publicité
Les langues disponibles
Les langues disponibles
Installation
7 Installation
7.1 Handling
7.2 Connections subsets
7.2.1 Fluid supply connection
582131110-2B0225-indA-EN.docx
Fluid sections of great weight and size must be handled
with suitable lifting equipment.
These fluid sections are intended to be coupled to motors
(pneumatic or hydraulic) compatible race.
It is imperative to comply with an air motor / hydraulic
combination provided by SAMES KREMLIN
Make sure that all connections of the pump and fluid
section components - cables, hoses and pipes - are installed
in such a way that they do not cause people to fall.
Make sure that the order in which the cables, hoses and
pipes are connected is in accordance with the connection
diagram.
Make sure that all cable connectors, hose and pipe
connections are correctly fitted.
Remember that unconnected or incorrectly connected
cables, hoses and pipes can lead to malfunctions that
endanger the safety of operating personnel.
If the supply pressure is higher than the max. pressure, it is
necessary to install a fluid pressure regulator in front of the
equipment.
Ensure that a short product hose reduces pressure
fluctuations and pressure drops.
Make sure that the fluid supply is properly made. The
nominal size of the fitting to be used depends on the
nominal size of the fluid hose.
27/10/2020
25
Publicité
