Bosch AVENAR Serie Guide D'installation page 37

All manuals and user guides at all-guides.com
AVENAR panel series
Pos. Designation
H Interface label Label including connector assignment
I 6-pin DIP
switch
J Product label
K 18 LEDs
3 Installation
The panel controllers may be mounted into the following
housings:
CPH 0006 A, MPH 0010 A, HCP 0006 A and HBC 0010 A.
For the installation, follow these instructions:
1. Make sure that the PRS-0002-C Panel Rail Short is mounted
before you start installing the Panel Controller.
2. Start assembling the hinge and the mounting bracket (see
02, page 5 ).
3. Connect the ground wire to the screw on the housing (see
04, page 7 ).
4. Plug the cable into the slot labeled IN of the PRS-0002-C
Panel Rail Short (see 05, page 8 ).
Note: Do not plug the cable into the slot labeled OUT nor
into the slots of the PRD 0004 A Panel Rail Long
(exception: cable to redundant panel).
5. Plug the EOL resistor for the databus into the slot labeled
OUT of the last PRD 0004 A Panel Rail Long in use (see 06,
page 9 ).
Attach the supplied label to the side of the housing (see 06,
6.
page 9 ).
Bosch Sicherheitssysteme GmbH
Function
DIP switch settings for CAN bus networking & panel
redundancy
Important product data
Indicating the operating status
Installation | en
2020.05 | 6.0 | F.01U.347.557
37