Publicité
Les langues disponibles
Les langues disponibles
Other functions
Changing the sound settings
Adjusting the sound
characteristics — BAL/FAD/SUB
You can adjust the balance, fader, and subwoofer
volume.
1
Press (SEL) repeatedly until "BAL,"
"FAD" or "SUB" appears.
The item changes as follows:
LOW*
1
t MID*
1
t HI*
BAL (left-right) t FAD (front-rear) t
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 11).
*2 When the audio output is set to "SUB"
(page 11).
"ATT" is displayed at the lowest setting, and can
be adjusted up to 20 steps.
2
Press the volume +/– button
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press <, M, ,
or m.
Adjusting the equalizer curve
— EQ3
You can adjust and store the equalizer settings
for different tone ranges.
1
Select a source, then press (EQ3)
repeatedly to select the EQ3 type.
2
Press (SEL) repeatedly until "LOW,"
"MID" or "HI" appears.
3
Press the volume +/– button
repeatedly to adjust the selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold (SEL) before the setting is
complete.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
1
t
2
With the card remote commander
In step 3, to adjust the selected item, press <, M, ,
or m.
Adjusting setup items — SET
1
Press and hold (SEL).
The setup display appears.
2
Press (SEL) repeatedly until the
desired item appears.
3
Press the volume +/– button to select
the setting (example "ON" or "OFF").
4
Press and hold (SEL).
The setup is complete and the display returns
to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and setting.
With the card remote commander
In step 3, to select the setting, press < or ,.
The following items can be set (follow the page
reference for details):
"
" indicates the default settings.
z
CLOCK-ADJ (Clock Adjust)
(page 4)
CT (Clock Time)
To set "ON" or "OFF" (
BEEP
To set "ON" (
) or "OFF."
z
SUB/REAR*
1
To switch the audio output.
– "SUB" (
): to output to a subwoofer.
z
– "REAR": to output to a power amplifier.
DIM (Dimmer)
To change the brightness of the display.
– "AT" (
): to dim the display automatically
z
when you turn the lights on.
– "ON": to dim the display.
– "OFF": to deactivate the dimmer.
CONTRAST
To adjust the contrast of the display.
The contrast level is adjustable in 7 steps.
M.DSPL*
2
(Motion Display)
To select the Motion Display mode.
– "SA" (
): to show moving patterns and
z
spectrum analyzer.
– "ON": to show moving patterns.
– "OFF": to deactivate the Motion Display.
DEMO*
1
(Demonstration)
To set "ON" (
) or "OFF" (page 4).
z
continue to next page t
) (page 9, 10).
z
11
Publicité
