Publicité
Les langues disponibles
Les langues disponibles
PEV-AW32 User Manual
7.4 Charger Installation Requirements
To select the best location and position to
install the wall-mount unit, you should first
determine the parking position of the
vehicle to ensure the charging connector
can be easily inserted into the vehicle
charging inlet. The wall-mount unit should be
located:
In a well-ventilated area. Avoid
•
installing in closed boxes or near the
exothermic chargers.
1.2 meters or 4 feet above the floor.
•
250mm (10inches) from any obstacles
•
to allow cables to loop around the
wires and related maintenance.
If in an enclosed garage, on the side
•
of vehicle charging inlet.
7.5 Installation Steps
Warning for Wi-Fi and 4G versions: Due to
different congenital environments, it is
recommended to first conduct Wi-Fi and 4G
module network signal tests before finalizing
your settings. It is recommended that the
RSSI (Received Signal Strength Indication)
value should be higher than-65dBm. If it is
lower than this value, it may result in a weak
Wi-Fi or 4G connection or disconnection due
to external interference in the area.
Step 1
Use screwdriver to loosen the 9 fixed screws
on the rear of charger, then remove the
front cover.
Step 2
Connect and lock the M25 waterproof
gland Part1 and Part2 (including the
washer) to the mounting holes as shown
below.
9
9
Publicité
