PlugEv PEV-AW32 Manuel De L'utilisateur page 13

PEV-AW32 User Manual
8. Operating Instructions
8.1 Operating Procedures
• User authorization (Only for Internet
Edition)
• Connect to Vehicle Charging Inlet
• Charging Message
• Charging Completed
8.2 Operating Steps – Non-Networking
Edition
Step 1
After power-on, the green (READY), blue
(CHARGE), and red lights (FAULT) will all light
up. The charger will then enter standby
mode, and the green light (READY) will
remain lit. This could take up to 90 seconds.
Step 2
Plug the charging cable into the vehicle
charging inlet. The blue light (CHAGE) is
constantly lit.
Step 3
When the blue light (CHARGE) starts to flash
automatically, the charging process has
begun.
13
13