Publicité
Les langues disponibles
Les langues disponibles
PEV-AW32 User Manual
6. Status Indicator LEDs
Standby –Green Light
The READY light is lit when it is in standby
mode.
RFID Authorization (Internet Edition) –
Green Light Flashing
The READY light is flashing after the RFID is
authorized.
Waiting for Charging –Blue Light
After the charger connector is connected to
the EV, the CHARGE light will be lit.
Charging – Blue Light Flashing
The CHARGE light will be flashing during the
charging session.
Fault –Red Light
Fault detected on the charger. The FAULT light
will be lit. See Troubleshooting section.
7. Installation Instructions
Safety Requirements
Read this user manual thoroughly
•
and make sure to review all local
building and electrical codes are
reviewed before installing the AC
charger.
A qualified technician should install
•
the AC charger according to the user
manual and local safety regulations.
Use appropriate protection when
•
connecting
distribution cable.
Type B, C or D breaker with a rating
•
current of 40Amp should be installed
in the upstream AC distribution box.
Disconnect
•
ungrounded conductor of AC input
shall be provided by others in
accordance
Electric Code, ANSI/ NFPA 70.
Verify that the Wall Connector is
•
properly
connection must be bonded in the
upstream power supply for proper
operation.
connections, including the wire box
terminals, electrical panel(s), and
junction boxes. In residential power
supplies, check the bond between
Ground and neutral at the main
panel. If connected to a step-down
transformer, contact the transformer's
manufacturer for direction on how to
bond the ground connection.
6
to the main power
switch
for
with
the
National
grounded.
The
Ground
Check
all
physical
6
each
Publicité
