Publicité
Les langues disponibles
Les langues disponibles
PEV-AW32 User Manual
8.8 Troubleshooting
Error and Warning Messages
Status
Input OVP
Input UVP
Output OCP
OTP
RCD Abnormal
*1
Ground Fault
Control Pilot
Fault
MCU Self-Test
Fail
RCD Self-Test Fail
Relay Self-Test
Fail
RCD Abnormal
*2
Stop Charging
Output OCP
Constantly
*2
Stop Charging
OTP Stop
Charging
*1 Verify that the Wall Connector is properly grounded. The Ground connection must be bonded in
the upstream power supply for proper operation. Check all physical connections, including the wire
box terminals, electrical panel(s), and junction boxes. In residential power supplies, check the bond
between Ground and neutral at the main panel. If connected to a step- down transformer, contact
the transformer's manufacturer for direction on how to bond the ground connection.
*2 Withdraw and re-plug the charging gun can exit this stop charging mode.
*3 If this stop charging mode is frequently triggered, please contact customer service for technical
solutions.
Blue
Green
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Constantly
-
Bright
-
Bright
Flicker
Flicker
Red
One flash followed by a 3-sec pause
Two flashes followed by a 3-sec pause
Three flashes followed by a 3-sec pause
Four flashes followed by a 3-sec pause
Five flashes followed by a 3-sec pause
Six flashes followed by a 3-sec pause
Flicker
Constantly Bright
Constantly Bright
Constantly Bright
Constantly Bright
Constantly Bright
Constantly Bright
21
Remark
Auto Recover
Auto Recover
Auto Recover
Auto Recover
Auto Recover
Auto Recover
Auto Recover
Contact Customer Service
Contact Customer Service
Contact Customer Service
Contact Customer Service
Contact Customer Service
Contact Customer Service
21
*3
*3
Publicité
