Publicité
Les langues disponibles
Les langues disponibles
PEV-AW32 User Manual
9. Industry Canada Statement
This device complies with ISED's licence-exempt
RSSs. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference
that
operation.
Radiation Exposure Statement:
This equipment complies with ISED radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with greater than 20cm between
the radiator & your body.
This device is intended only for OEM integrators
under the following conditions: (For module
device use) 1) The antenna must be installed
and operated with greater than 20cm between
the antenna and users, and 2) The transmitter
module may not be co-located with any other
transmitter or antenna. As long as 2 conditions
above are met, further transmitter test will not
be required. However, the OEM integrator is still
responsible for testing their end-product for any
additional compliance requirements required
with this module installed.
IMPORTANT NOTE: In the event that these
conditions can not be met (for example certain
laptop configurations
another
transmitter),
authorization is no longer considered valid and
the IC ID can not be used on the final product.
In these circumstances, the OEM integrator will
be responsible for re-evaluating the end
product
(including
obtaining a separate Canada authorization.
may
cause
undesired
or co-location with
then
the
Canada
the
transmitter)
10. Maintenance and Repair
10.1 Daily Maintenance
Please keep the charger clean and keep
the charger in a clean area with low
humidity. Do not install it in an environment
near the sea, with high oil, high humidity or
high dust.
•
Avoid moisture or water in the charger. If
water or excess moisture gets into the
charger, immediately power off the
charger to avoid immediate danger.
Proceed to contact the appropriate
maintenance personnel before the next
use.
•
If there is any damage or dirt on the
vehicle connector, charging cable, or
vehicle
contact the maintenance personnel
immediately.
•
Please use the charger correctly. Do not
hit or press hard on the case. If the case
is
professional technician.
•
Avoid placing the charger near hot
objects
locations and away from dangerous
substances such as flammable gases
and corrosive materials.
•
Do not place external objects or heavy
objects on the charger to avoid danger.
and
22
connector
damaged,
please
and
at
high
22
holder,
please
contact
a
temperature
Publicité
