Viscount Prestige 60 Guide Rapide page 34

Viscount Prestige 60
10. [O.SOLO] button: this button controls the status of the Organ Solo function. By activating
this function plus the coupling II/I the voices of the second manual can be played on the first
manual in monophony with priority given to the highest note. On the second manual the voices
continue to sound in polyphony.
11. [A.P.] button: this button enables the Automatic Pedal, used to play the voices of the pedal
board using the first 32 notes of Man.I. In this case, the organ pedal board is deactivated and the
voices become monophonic, with priority given to the lowest note.
12. Floppy disk drive: use only 720 Kb or 1.44 Mb 3.5" floppy disks.
13. [C] button: "Cancel" button, which switches off any voices, couplers and buttons on the manual
divisionals which may be on and turns the HR buttons on.
2.5 PEDAL BOARD CONTROLS
1. General memory pistons: these pistons can be used to recall the organ general memories.
2. [CRESCENDO] pedal: this pedal can be used to select the Crescendo steps which activate a
preset series of stops. The step currently selected is displayed by the [CRESCENDO] LED bar
on the centre panel (see also point 1 of par. 2.3).
Each Crescendo step is programmable. To do this, use the [CRESCENDO] pedal to select the
step required, switch on the voices and couplers needed, press button [S] and, keeping it pressed
down, then press the general memories [HR] button.
3. [MAN. II] pedal: this expression pedal is used to control the volume of the second manual.
4. [MIDI SUSTAIN] piston: Sustain piston of the Orchestra voices and by which CC64 is sent
to the [MIDI OUT].
5. [TUTTI] piston: the piston used to activate the Tutti. For a more detailed description, refer to
point 8 of par. 2.4.
- Quick Guide
1
CRESCENDO MAN. II
2 3
32
4 5